Onkyo TX-SR600 Bedienungsanleitung PDF herunterladen (Seite 35)

Connecting antennas

Outdoor antenna

(Indoor)

AM loop antenna

To TV (or VCR)To receiver

Connecting an FM outdoor antenna

Make sure to follow the general rules given below:

• Keep the antenna away from noise sources (neon signs, busy

roads, etc.).

• It is dangerous to put the antenna close to power lines. Keep it

well away from power lines, transformers, etc.

• To avoid the risk of lightning and electrical shock, grounding is

necessary. Follow item 14 of the “Important Safeguards” on

page 2 when you install the outdoor antenna.

Connecting an AM outdoor antenna

If reception is poor with the indoor AM antenna, stretch out the

outdoor antenna (16 feet (5 meters) or more) above a window or

outside.

• Keep the indoor AM loop antenna connected. Do not remove it.

• To avoid the risk of lightning and electrical shock, grounding is

necessary. Follow item 14 of the “Important Safeguards” on

page 2 when you install the outdoor antenna.

Note:

If you are using the TX-SR700/700E/600/600E worldwide model in

a region where AM frequencies are delineated by 10-kHz steps, be

sure to set the “AM Frequency Step” Setup setting accordingly (see

page 56).

ANTENNA

Directional linkage

Do not use the same antenna for both FM and TV (or VCR)

reception since the FM and TV (or VCR) signals can interfere with

each other. If you must use a common FM/TV (or VCR) antenna, use

a directional linkage type splitter.

Connecting the antenna cable to the 75/300 Ω

antenna adapter (For all models other than USA &

Canadian models and European models)

Connecting the 300 Ω ribbon wire:

Loosen the screws on the adapter and wrap the wires of the ribbon

wire around these screws. Then tighten the screws down with a

screwdriver.

Connecting the coaxial cable:

1. With your fingernail, or a small screwdriver, press the

stoppers of the 75/300 Ω antenna adapter outward

and remove the cover.

2. Remove the transformer wire A from slit B and insert

it into slit C.

3. Prepare the coaxial cable as shown in the diagram.

4. Connect the 75/300 Ω antenna adapter to the coaxial

cable.

1. Insert the end of the cable.

2. Clamp it in place with pliers.

5. Reinstall the cover.

Outdoor

antenna

300 Ω

ribbon wire

Slit B

Wire A

Slit C

1 2 3, 4

✦

5/8"

(15mm)

ANTENNA

COAXIAL

OPTICAL

DIGITAL INPUT

VIDEO 2

VIDEO 3

OPTICAL

OUT

DIGITAL

OUTPUT

PHONO IN

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare

Onkyo TX-SR600 Bedienungsanleitung Seite 35

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Akustik Onkyo TX-SR600