Onkyo TX-SR804E Bedienungsanleitung PDF herunterladen (Seite 59)

Common Functions

—Continued

With the sleep timer, you can set the AV receiver so that

it turns off automatically after a speciﬁed period.

To cancel the sleep timer,

press the [SLEEP] button

repeatedly until the SLEEP indicator disappears.

To check the remaining sleep time,

press the [SLEEP]

button. Note that if you press the [SLEEP] button while

the sleep time is being displayed, you’ll shorten the sleep

time by 10 minutes.

For private listening, you can connect a pair of stereo

headphones (1/4-inch phone plug) to the AV receiver’s

PHONES jack.

Notes:

•Always turn down the volume before connecting your

headphones.

• The speakers are turned off while the headphones plug

is inserted in the PHONES jack. (The Zone 2 speakers

are unaffected.)

• When you connect a pair of headphones, the listening

mode is set to Stereo, unless it was set to Pure Audio,

Mono, Stereo, or Direct, in which case it stays the

same.

You can display various information about the current

input source as follows.

The following information can typically be displayed:

*If the input signal is analog, no format information is

displayed. If the input signal is PCM, the sampling fre-

quency is displayed. If the input signal is digital but not

PCM, the signal format is displayed.

If the input signal is multichannel PCM, the sampling

frequency and signal format will be displayed. Informa-

tion is displayed for about 3 seconds, then the previous

display reappears.

Interpreting Surround Channel Information

A: The number of front channels (front left, front right,

and center).

B: The number of surround channels (surround left and

surround right). If there’s surround back channel

information, this number will be 3.

C: LFE channel for subwoofer (1 means yes).

Using the Sleep Timer

Press the remote controller’s

[SLEEP] button repeatedly to

select the required sleep time.

You can set the sleep time from 90 to 10

minutes in 10 minute steps.

The SLEEP indicator appears on the

display when the sleep timer has been

set, as shown. The speciﬁed sleep time

appears on the display for about 5 sec-

onds, then the previous display reap-

pears.

Using Headphones

SLEEP

SLEEP indicator

OFFZONE 2

PHONES

STANDBY/ON

STANDBY

ZONE 2

PURE AUDIO

OFF

POWER

Displaying Source Information

Press the [DISPLAY] button

repeatedly to cycle through the

available information.

DISPLAY

Remote

controller

AV receiver

Input source &

volume

Signal format*

or sampling

frequency

Input source &

listening mode

ABC

TX-SR804/804E_En.book Page 59 Monday, September 4, 2006 9:34 AM

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 95 96

Kommentare zu diesen Handbüchern

Keine Kommentare

Onkyo TX-SR804E Bedienungsanleitung Seite 59

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Onkyo TX-SR804E